Canyon/Acros AI70 Headset Bearing Set | By Kinetic
Canyon/Acros AI70 Headset Bearing Set | By Kinetic
Brand
ACROS
Share This
Alternative Non-Acros version of this bearing set
Used On: Canyon Bikes that run the AI-70 Headset (NOTE, This does not fit Canyon Endurance, Ultimate, Aeroad SLX 2016 onwards)
Refer to the Canyon web site for technical data for your year of bike if you are in any doubt if this is the correct Headset for your Canyon.
This is a Bearing 'set' which consists of an upper and lower heasdset bearing & compression ring.
Lower Bearing (AC3748)
Inner x Outer x Depth (mm): 37 x 48 x 7
Angle / Chamfer (Deg): One chamfer 45 Deg only on the inner side
Upper Bearing (6707-2RS)
Inner x Outer x Depth (mm): 35 x 44 x 5
Angle / Chamfer (Deg): Non
NOTE, This does not fit Canyon SLX Models 2016 onwards (see separate listing)
Refer to the Canyon web site for technical data for your year of bike if you are in any doubt if this is the correct Headset for your Canyon.
Important to note: This is a Bearing 'set' which consists of an upper and lower heasdset bearing & compression ring
Lower Bearing
Inner x Outer x Depth (mm): 37 x 48 x 7
Inch Dia: 1-1/4”
Angle / Chamfer (Deg): One chamfer 45 Deg only on the inner side
Seal: Double-sealed 2RS
Material: Chrome Steel (Race & Balls)
Upper Bearing
Inner x Outer x Depth (mm): 35 x 44 x 5
Inch Dia: 1-1/4”
Angle / Chamfer (Deg): No Chamfers
Seal: Double-sealed 2RS
Material: Chrome Steel (Race & Balls)
Used On: Canyon Bikes that run the AI-70 Headset.
Installation: The lower bearing must be handled with great care - it is internally angular contact which rely's on the inner and outer races to have the play dialed out. To achieve this the races are pressed together and can easily separate when removing fork (which can result in the ball bearings falling out). There is no alternative design/construction option for this bearing. We cannot be held liable in future, if mishandling or bad installation results in races separating.
| size | 1 |
|---|