Slide Hammer Bearing Extractor Tool with 8 Expanding Collet attachments
Slide Hammer Bearing Extractor Tool with 8 Expanding Collet attachments
Slide Hammer Bearing Extractor Tool with 8 Expanding Collet attachments
Universal Slide Hammer to assist in removing bearings from Hubs, Frames and Bottom Brackets.
8 Split Collets of various sizes opened up within inner bearing race. Slide Hammer then attached by a thread and bearings can be extracted.
Collets (Drop forged heat treated attachments of following sizes):
- 8~10mm (5/16"~13/32")
- 10~12mm (13/32"~15/32")
- 12~14mm (15/32"~9/19")
- 15~17mm (9/32"~11/16")
- 17~20mm (11/16"~25/32")
- 20~24mm (25/32"~15/16")
- 25~29mm (1"~1-1/8")
- 30~32mm (1-3/16"~1-1/4")
3 Pound Slide Hammer 100mm / L -2. 15LB (940g) with T-Handle
Slide Hammer Shaft 390mm long.
Important note, to keep cost down to a minimum the collets are made from forged steel. The compromise, is that the material can be quite brittle in it's material properties. Please keep this in mind when expanding the prongs on the collets. The prongs can break off if tool expanded too far. We cannot warranty any collets with broken collet prongs. Where possible, we do carry spare Collets for sale.
size | 1 |
---|
**Reminder** It's almost bank holiday weekend, so allow extra time to receive your order... orders received after 3pm on Thursday 28th March, will not leave us until Tues 2nd April. Thank you!